ABS and ASA: heat-resistant and weatherproof
ABS and ASA compared: key values, why an enclosure is needed, warping, fumes, acetone smoothing and outdoor use.
As of November 2026
ABS is the plastic of many mass-produced housings and toy bricks. ASA is a close chemical relative that also withstands UV light and weather. Both resist heat better than PLA and PETG but ask more of the printer.
Key values
| Property | ABS | ASA |
|---|---|---|
| Nozzle temperature | 240 to 260 °C | 240 to 260 °C |
| Bed temperature | 90 to 110 °C | 90 to 110 °C |
| Softening (glass transition) | about 100 to 105 °C | about 100 °C |
| Tensile strength | about 35 to 45 MPa | about 40 to 50 MPa |
| UV resistance | low, yellows | very good |
| Density | about 1.04 g/cm³ | about 1.07 g/cm³ |
Why the printer should be enclosed
Both plastics shrink noticeably as they cool. If a part cools unevenly, corners lift off the plate (warping) or layers crack apart. A closed, warm chamber keeps the temperature even. Large flat parts are the most vulnerable.
Fumes
Printing releases styrene fumes and ultrafine particles. ABS and ASA belong in a printer with an enclosure and filter, or in a well-ventilated room where nobody stays for long.
Strengths
- dimensionally stable up to about 95 °C
- impact-resistant and easy to work: drill, sand, paint
- ASA keeps its colour and shape outdoors for years
- ABS can be smoothed with acetone vapour and glued with acetone
- low density, light parts
Weaknesses
- warping and layer cracks without an enclosure
- smell and emissions
- dimensions are harder to hold than with PLA
- high bed temperature, longer warm-up
ABS or ASA?
For anything that sees the sun, ASA is the right choice. ABS is worthwhile when the surface is to be acetone-smoothed or price matters. In most other cases ASA has replaced ABS.
What the two suit
Parts in and on vehicles, garden equipment, outdoor antenna and camera mounts, housings near heat sources, ventilation parts, machine covers.
FAQ
Does ASA survive in a car behind the windscreen?
Usually yes. Temperatures there reach 70 to 80 °C, which ASA withstands. Dark parts in direct sun can get hotter; polycarbonate or nylon is then the better choice.
Can ABS be printed at home?
With an enclosed printer and good ventilation, yes. On an open machine only small parts succeed reliably.
Our own service: 3D Druck Berlin makes ASA parts for vehicles and outdoor use, including rebuilds of parts no longer available: car and classic car parts.
More topics
- PLAThe standard plastic for beginners: easy, accurate, not heat-resistant.
- PETGTougher and more heat-resistant than PLA, moisture-resistant, a little more demanding.
- TPURubbery, abrasion-resistant, tear-resistant. For anything that has to give.
- Nylon, PC and fibre-filledEngineering plastics for high load, heat and wear.