PETG: the tough all-rounder for functional parts
PETG in 3D printing explained: key values, differences from PLA, typical print problems such as stringing, and suitable uses.
As of November 2026
PETG is PET modified with glycol, related to the plastic of drinks bottles. It combines easy processing with good toughness, which makes it the standard material for parts that have to take some stress.
Key values
| Property | Guide value |
|---|---|
| Nozzle temperature | 230 to 250 °C |
| Bed temperature | 70 to 85 °C |
| Softening (glass transition) | about 75 to 80 °C |
| Tensile strength | about 45 to 55 MPa |
| Elongation at break | clearly higher than PLA |
| Density | about 1.27 g/cm³ |
PETG and PLA compared
| PLA | PETG | |
|---|---|---|
| Stiffness | higher | slightly lower |
| Impact toughness | low | good |
| Heat resistance | to about 55 °C | to about 75 °C |
| Moisture and chemicals | moderate | good |
| Detail sharpness | very good | good |
| Stringing | little | more frequent |
| Surface | matt to silky | glossy |
Strengths
- tough, not brittle: it deforms before it breaks
- very good bonding between layers
- resists water, many cleaners and weak acids
- hardly any warping, no enclosure needed
- also available transparent
Weaknesses
- tends to leave fine strings between separate areas
- overhangs and bridges come out less cleanly than in PLA
- sticks very firmly to smooth build plates and can damage them
- scratches more easily
- absorbs moisture and should be stored dry
What PETG suits
Brackets, workshop helpers, housings with snap closures, kitchen and bathroom parts without direct food contact, planters, mechanically loaded prototypes, covers.
What it does not suit
Permanent outdoor use in full sun (ASA is better), parts above 75 °C, very fine lettering and filigree detail.
Print tips
- print a little slower than PLA
- reduce part cooling, which improves layer bonding
- dry the filament first if bubbles or crackling appear
- use a textured build plate or a release agent
FAQ
Is PETG UV-resistant?
Better than PLA, but not permanently. For several years outdoors, ASA is the safer choice.
Can PETG be glued?
Yes, with superglue or two-part adhesives. Solvent welding as with ABS does not work.
Our own service: PETG brackets and adapters are among the most common orders at 3D Druck Berlin. See brackets and adapters, or get a price from the instant quote.