PLA: properties, print settings and limits
All about PLA in 3D printing: mechanical values, temperature limits, variants such as PLA+ and silk, typical settings and uses.
As of November 2026
PLA (polylactic acid) is the most printed plastic in FDM. It is made from plant starch, processes at low temperature and hardly warps. For most display and indoor parts it is the sensible first choice.
Key values
| Property | Guide value |
|---|---|
| Nozzle temperature | 190 to 220 °C |
| Bed temperature | 50 to 65 °C |
| Softening (glass transition) | about 55 to 60 °C |
| Tensile strength | about 50 to 60 MPa |
| Elongation at break | low, about 3 to 6 % |
| Density | about 1.24 g/cm³ |
| Shrinkage | very low |
Values vary by manufacturer and colour.
Strengths
- prints without trouble, even without an enclosure
- very good detail and sharp edges
- high stiffness
- hardly any smell while printing
- the widest choice of colours and effects
Weaknesses
- softens from about 55 °C: unsuitable for cars, sunny windowsills and dishwashers
- brittle; it tends to snap under impact
- creeps under constant load, so screwed joints loosen over time
- ages outdoors from UV light and moisture
Variants
- PLA+ / tough PLA: additives make it tougher and a little more impact-resistant
- Silk PLA: glossy surface, slightly weaker layer bonding
- Matt PLA: hides layer lines and looks high-quality
- Wood, marble and metal look: PLA with fillers, some abrasive to the nozzle
- PLA-CF: with carbon fibre, very stiff and matt
- High-temperature PLA: becomes more heat-resistant when annealed after printing, but shrinks in the process
What PLA suits
Models, figures, prototypes for checking shape, indoor electronics housings, organisers, signs, decoration, classroom projects.
What it does not suit
Parts in vehicles, outdoor use over years, permanently loaded brackets, snap hooks that are used often, anything in contact with hot liquids.
On the environmental balance
PLA is based on renewable raw materials. "Biodegradable", however, only holds under industrial composting conditions. In a home compost heap or in nature a PLA part lasts for years.
FAQ
Is PLA food-safe?
The pure plastic is common in food packaging. That does not make a printed part food-safe: colour additives, the nozzle and the grooves between layers all argue against it. Lasting food contact needs certified material and a suitable sealant.
How should PLA be stored?
Dry and away from light. Damp filament turns brittle and prints with bubbles and strings.
Our own service: The PLA colours and other materials printed by 3D Druck Berlin are listed on its materials page. For help deciding, see Choosing a material.
More topics
- PETGTougher and more heat-resistant than PLA, moisture-resistant, a little more demanding.
- ABS and ASAFor heat, vehicles and outdoors. Needs an enclosed printer.
- TPURubbery, abrasion-resistant, tear-resistant. For anything that has to give.
- Nylon, PC and fibre-filledEngineering plastics for high load, heat and wear.