Nylon, polycarbonate and fibre-reinforced plastics
Engineering filaments at a glance: PA6 and PA12, polycarbonate, and carbon- and glass-fibre-reinforced grades, with key values and limits.
As of November 2026
When PLA, PETG and ASA are no longer enough, engineering plastics come into play. They are stronger, more heat-resistant or more wear-resistant, but demand dry storage, high temperatures and often hardened nozzles.
Nylon (polyamide, PA)
Nylon is tough, low-friction and wear-resistant. It suits gears, hinges, plain bearings and snap hooks that are operated thousands of times.
- PA6: stronger and more heat-resistant, absorbs a lot of moisture
- PA12: more dimensionally stable, absorbs less moisture, the standard powder-bed material
Its main quirk: nylon draws water from the air. Damp filament prints foamy and weak. It has to be dried before printing and fed dry. The finished part also takes up moisture, becoming tougher but less stiff.
Polycarbonate (PC)
Polycarbonate is the plastic of safety glasses and machine guards. It is extremely impact-resistant and stays stable above 110 °C. Printing calls for nozzle temperatures around 270 to 300 °C and a closed, warm chamber. Blends with ABS or PETG are easier to process.
Fibre-reinforced plastics
Short carbon or glass fibres in the filament raise stiffness and heat deflection considerably and reduce warping. The surface turns matt and hides layer lines.
| Material | Characteristic |
|---|---|
| PLA-CF | very stiff, easy to print, still not heat-resistant |
| PETG-CF | stiff and a little more heat-resistant, a good everyday balance |
| PA-CF | high strength and heat resistance, the classic jig material |
| PA-GF | a little tougher than PA-CF, cheaper |
| PC-CF | for high temperatures and stiffness |
Two points matter. The fibres are abrasive and wear brass nozzles quickly, so hardened nozzles are used. And fibre-filled parts are stiffer but more brittle: they break instead of bending.
Key values compared
| Material | Stable up to about | Character |
|---|---|---|
| PA12 | 90 to 100 °C | tough, low-friction |
| PA6-CF | 150 °C and more | very stiff and strong |
| PC | 110 to 120 °C | extremely impact-resistant |
| PETG-CF | 80 °C | stiff, easy |
What these materials suit
Assembly jigs and gauges, robot grippers, brackets in engine bays, gears and slideways, drone frames, tool handles, protective covers.
When they are overkill
For a housing on a shelf or an unloaded bracket, engineering plastics bring no benefit. They cost two to five times as much and lengthen print time.
FAQ
Can 3D-printed nylon replace metal?
For jigs, brackets and covers often yes, especially fibre-reinforced. For load-bearing, safety-critical or hot components, not without calculation and testing.
Why are CF parts matt black?
The carbon fibres colour the material dark. Light colours are available in glass-fibre-reinforced grades.
Our own service: 3D Druck Berlin makes jigs, gauges and assembly aids in engineering plastics for businesses: jigs and fixtures and business customers.
More topics
- PLAThe standard plastic for beginners: easy, accurate, not heat-resistant.
- PETGTougher and more heat-resistant than PLA, moisture-resistant, a little more demanding.
- ABS and ASAFor heat, vehicles and outdoors. Needs an enclosed printer.
- TPURubbery, abrasion-resistant, tear-resistant. For anything that has to give.