MJF: Multi Jet Fusion for series parts in nylon
Multi Jet Fusion at a glance: how the process works, how it differs from SLS, and which materials and tolerances are usual.
As of November 2026
Multi Jet Fusion (MJF) is a powder-bed process that reached the market in 2016. Like SLS it works with nylon powder, but it fuses each layer across its whole area instead of with a laser.
The process
- A thin layer of powder is spread.
- A print head, much like an inkjet printer's, applies a heat-absorbing fluid wherever the part should form.
- At the edges a second fluid is applied that inhibits fusing and gives sharp edges.
- Infrared lamps pass over the layer. The wetted powder absorbs the heat and fuses.
- This repeats layer by layer. The chamber then cools and the parts are depowdered.
Because each layer is exposed in one pass, print time hardly depends on how full the chamber is.
MJF and SLS compared
| MJF | SLS | |
|---|---|---|
| Energy source | infrared lamps plus fluid | laser |
| Base colour | grey | white |
| Usual final colour | dyed black | white, dyed or painted |
| Surface | slightly finer, more even | slightly rougher |
| Detail sharpness | very good on small features | good |
| Strength | very even in all directions | almost even |
| Speed with a full chamber | high | medium |
| Light colours | difficult because of the grey base | readily possible |
Materials
- PA12: the standard, balanced and dimensionally stable
- PA11: tougher and more elastic
- PA12 with glass beads: stiffer
- TPU: elastic
- PP: light and chemical-resistant
Typical values
| Quantity | Usual range |
|---|---|
| Layer height | about 0.08 mm |
| Dimensional tolerance | about ±0.2 to ±0.3 mm or ±0.3 % |
| Minimum wall thickness | 0.5 to 0.8 mm |
| Smallest detail | about 0.5 mm |
Design rules
The same principles apply as for SLS: openings for depowdering, even walls, stiffened flat areas. It also pays to hollow out thick sections or fill them with lattices, because solid material shrinks more.
Strengths
- uniform mechanical properties
- fine detail and sharp edges
- economical from a few dozen parts
- well reproducible from order to order
Limits
- grey base colour, so usually dyed black
- like SLS, only available from service providers
- cooling time extends delivery
- single parts cost more than in FDM
What MJF is the first choice for
Small series of housings, clips, connectors and brackets; end products in quantities from ten to a few thousand; parts with fine latches or living hinges.
FAQ
When SLS, when MJF?
For black functional parts in series, MJF is often cheaper and more uniform. For white parts or parts to be dyed in colour, SLS has the edge. For single parts, what usually decides is which machine the provider is currently filling.
From what quantity is injection moulding worth it over MJF?
As a rough guide, from a few hundred to a few thousand pieces, depending on part size and tooling cost. Below that a powder-bed process is usually cheaper.
More topics
- FDM / FFFPlastic filament is melted and laid down in lines. The most widespread process.
- SLA / resinLiquid resin is cured with light. For the finest detail and smooth faces.
- SLSA laser fuses nylon powder. Durable parts without supports.
- MetalLaser melting and related processes for steel, aluminium and titanium.