3D Druck DeutschlandProcessesMaterialsPracticeLexiconFAQOur servicesBasicsWhat 3D printing costsAbout this siteDeutsch

Understanding slicer settings: layer height, walls, infill, supports

The main slicer settings explained, with their effect on quality, strength and print time, and sensible starting values.

As of November 2026

The slicer is the program that turns a 3D model into print paths. Its settings shape the result more than the printer itself. If you order from a service, you will meet the same terms in the quote.

The six most important settings

Layer height

It determines how fine the steps on slopes are, and affects print time almost linearly.

Layer height Effect Typical for
0.08 to 0.12 mm very fine, long print time figures, visible parts
0.16 to 0.2 mm a good compromise most parts
0.24 to 0.3 mm fast, visibly stepped large parts, functional samples

Wall lines

The number of outer lines. Two are enough for models, three to four for loaded parts. Walls contribute most to strength.

Infill

Given as a percentage. 10 to 15 percent is enough for display models, 20 to 40 percent for functional parts. Above 50 percent adds little strength relative to time and material.

Common patterns: grid (fast), gyroid (even in every direction), honeycomb (strong, slower), cubic (a good all-rounder).

Top and bottom layers

The number of closed layers above and below. As a rule of thumb, top and bottom should each be about 0.8 to 1 mm thick so the infill pattern does not show through.

Supports

Bed adhesion

Other settings worth knowing

Orientation first

Before changing numbers, the position of the part should be right. Three questions help:

  1. Which face lies flat on the plate?
  2. Where does the force act, and do the layers run along it?
  3. Which face is visible and should stay free of supports?

Sensible starting values

Setting Value
Layer height 0.2 mm
Wall lines 3
Infill 15 to 20 %, gyroid or grid
Top and bottom 4 to 5 layers
Supports only where needed, tree supports
Adhesion skirt, brim if warping occurs

FAQ

Does more infill always make a part stronger?

Noticeably up to about 40 percent, hardly beyond. One extra wall line usually does more than ten percentage points of infill.

Which slicer is the right one?

The common free programs all give good results. For beginners the printer maker's own slicer is easiest, because its profiles are tuned.

Our own service: If you have a finished file and would prefer to skip the settings, upload it to 3D Druck Berlin: print my STL.

More topics