Your first 3D print, step by step
From unboxing to finished part: setting up, loading filament, choosing a model, slicing, printing and avoiding the typical beginner mistakes.
As of November 2026
A current beginner's printer is ready in half an hour. This sequence leads reliably to a first usable part.
1. Set up
- a stable, level table that does not wobble
- no draught, no direct sun
- a room that is easy to ventilate, not the bedroom
- a smoke detector in the room
2. Commission
Remove the transport locks, switch on and follow the guided setup. Most machines measure their own build plate. On older models the gap between nozzle and plate is set by hand, usually with a sheet of paper as a gauge.
3. Load filament
Start with PLA. Heat the nozzle, feed the filament until material comes out. Hang the spool so it unwinds freely.
4. Choose a model
To begin, a small, proven test model that finishes in under an hour. Calibration cubes and small test figures show at once whether dimensions, overhangs and details are right. The big model platforms hold millions of free designs.
5. Slice
Load the model into the slicer, pick the printer and material, take the standard profile at 0.2 mm layer height. Look at the preview: does the part lie flat? Are supports needed? Then export or send straight to the printer.
6. Print and watch
Look at the first layer. It should lie evenly, slightly pressed down and without gaps. If it succeeds, the rest usually runs through.
7. Remove
Let the plate cool. Parts pop off flexible spring-steel plates when you bend them. Do not force a tool under the part.
The five most common beginner mistakes
- Touching the plate with your fingers. Skin grease prevents adhesion. Clean with isopropanol or washing-up liquid.
- Too large a first project. A 20-hour print as a start is frustrating. Begin small.
- Changing too many settings. The standard profile is almost always a good start.
- Leaving filament in the open. Store it in a box with desiccant.
- Printing without a preview. The slicer's layer view shows most problems in advance.
What you learn in the first weeks
- how orientation affects strength and surface
- when supports are needed and how to avoid them
- how different materials behave
- designing simple parts of your own
FAQ
Do I have to stay with the printer?
For the first layers, yes. After that modern machines run independently, and many have a camera. Only leave it fully unattended overnight if you know the machine and have a smoke detector in the room.
How loud is a 3D printer?
Roughly like a dishwasher, depending on machine and speed. Enclosed machines are quieter.
Our own service: If you first want to find out whether 3D printing solves your problem, have the first part printed. This is how an order works at 3D Druck Berlin: how it works. The trade-off is covered under buy a printer or use a service.
More topics
- Design rulesGuide values for walls, overhangs, holes, lettering and joints.
- Tolerances and fitsWhat accuracy is realistic and how to design fits.
- Slicer settingsWhich setting does what, and where to start.
- Post-processingFrom raw print to finished part: sanding, painting, gluing, inserts.
- Fixing print defectsThe typical faults, their causes and what helps.
- CAD programsFrom browser building blocks to parametric CAD: what suits whom.
- 3D scanningPhotogrammetry, structured light, laser: what a scan delivers and where it ends.
- Buying a 3D printerDesigns, features, price classes and running costs, without brand advertising.
- Finding modelsWhere ready-made 3D models are and how to spot good ones.